Let's Go Shopping
ED702 - Synth-A-Scope
Let's Go Shopping

The ED702 is a single-channel oscilloscope ideal for monitoring signals in your system.

Parameter Value
Real-time sampling rate 1MSPS (max)
Sensitivity 1V/div - 5V/div in "1-2-5" steps
Timebase 10uS/div - 500uS/div in "1-2-5" steps
Capture buffer size 1024 bytes
Trigger modes Automatic/Normal/Single
Display size 2.4" (61mm)
Display resolution 320 pixels x 240 pixels
Input impedance 1M ohm/20pF
ADC resolution 12-bits

The DataLogger section at the top of the screen displays:-

  • Vpp - Shows the difference between the extreme Maximum and Minimum values
  • Vavr - The Average reading is the mean vertical level of the entire captured waveform
  • Freq - The Frequency is the inverse of the Period and is measured in Hertz

Pressing the [SELECT] button steps the user through the various control settings displayed around the edge of the screen, the currently active setting being highlighted within a blue frame. At each setting, pressing the [-] and [+] buttons will step through the available options.Pressing the [HOLD/OK] button will freeze the current display allowing for closer inspection of the input signal. Pressing the [HOLD/OK] button while in the lower left corner of the screen, the user can toggle the [AUTO SIZE] ([A.S]) function on and off. When enabled, [A.S] will automatically resize the input signal to fill the scope display area. This is useful when you have a signal on the display which doesn't optimally fit in any of the [VOLTS/DIV] settings. The DataLogger still displays the correct data for the input signal.

A DotCom 5U version is also available

Module Width
Module Depth
+12V @
-12V @

Build Guide

Email:  elby-designs@bigpond.com
© Copyright 2000. All rights reserved.     Revised: June 6, 2022