Build Guide - Calibration

 

  1. Set JP1 to ‘+’ and JP2 to ‘0’
  2. Set P101 to its mid-position
  3. Set [RISE] and [FALL] to ‘5’
  4. Select 'LOOP' mode (switch down)
  5. Monitor the output [DC]
  6. Turn P101 clockwise until the output starts oscillating
  7. Adjust P101 until the output is 5Vp-p
Email:  elby-designs@bigpond.com
© Copyright 2000. All rights reserved.     Revised: July 27, 2026