3D Model	Overlay	Plan View
Column 1 PCB
Column 2 PCB

Constructors should refer to the Component Overlays along with,
the Bill of Materials 3.5mm 4mm for the current value of all components, and
the General Construction Notes for general PCB assembly guidelines.

1. Assemble the Jack Carrier board
2. Fit all components to their respective PCBs except for the sub-assemby
3. Mount the Jack carrier sub-assembly on to the Column 2 PCB but do not solder
4. Offer the Column 2 assembly up to the front panel and secure using the supplied nuts and washers
5. Solder the Jack Carrier sub-assembly in to position
6. Mount the Column 1 assembly and secure using the supplied nuts
7. Connect the Column 1 and Column 2 PCBs using the supplied IDC cable