Build Guide - Calibration
  1. Set [RISE] and [FALL] pots to about ‘4’
  2. Set the [CYCLE] switch down
  3. Push the switches on the [VC RISE] and [VC FALL] pots (selects 'linear mode')
  4. Set the [VC RISE] and [VC FALL] pots to ‘0’
  5. Monitor the [DC] output
  6. Adjust P101 until the amplitude of the output is 5Vp-p
Email:  elby-designs@bigpond.com
© Copyright 2000. All rights reserved.     Revised: December 6, 2023