3D Model	Overlay	Plan View
PCB

Constructors should refer to the PCB Bill of Materials for the current value of all components,

and the General Construction Notes for general PCB assembly guidelines.

For designs like the Vintage Voltron 1 where the CGS592 is used as a VC Slew module, you will need to make some small changes to the build to convert the STEPPED unit in to a 2nd SMOOTHED unit:-

1. Swap R204 and R205
2. Replace C201 (220nF) with a 100nF polyester capacitor
3. Remove JP1, R403 and C401
4. Fit a wire link between the top pad of JP1 and the top pad of R403
5. You should then wire the [HOLD] jack for this 2nd SMOOTH section to J402.