Build Guide - Calibration

  1. Set mode to [XY]

  2. Monitor [OUT]

  3. Adjust P201 for 0V output

  4. Apply +6VDC to [VC-X] and [VC-Y]

  5. Adjust P101 for an output of 6VDC

  6. Remove the +6VDC

  7. Connect a sawtooth to [X]

  8. Adjust P102 for minimum AC feedthrough

  9. Move the sawtooth to [Y]

  10. Adjust P201 for minimum AC feedthrough
Email:  elby-designs@bigpond.com
© Copyright 2000. All rights reserved.     Revised: October 24, 2025