Build Guide - Calibration

 

 

 

  1. Set P104 fully counter-clockwise and then apply 3 full clockwise turns align="left">Set [RANGE] to ‘HI’
  2. Patch [BAND] to [IN]
  3. Set the [IN] level control to maximum
  4. Set [Q] to maximum
  5. Monitor [LO]
  6. Apply 0.0V to [1V/OCTAVE]
  7. Adjust [FREQUENCY] to produce an output running at 110Hz
  8. Apply 3.0V to [1V/OCTAVE]
  9. Turn P104 about 1/4-turn clockwise
  10. Repeat steps (7) to (10) for an accurate transpose of 3 octaves (110Hz and 880Hz)

 
Email:  elby-designs@bigpond.com
© Copyright 2000. All rights reserved.     Revised: October 4, 2026