Build Guide - Calibration
  1. Connect 0.0VDC to [CV IN]
  2. Connect a 1Hz 5VDC squarewave to [CLOCK]
  3. Wait for about 5 seconds
  4. Monitor TP1 and adjust P201 for a reading of 0.0V
  5. Monitor TP2 and adjust P202 for a reading of 0.0V
  6. Monitor TP3 and adjust P203 for a reading of 0.0V
  7. Connect 5.0VDC to [CV IN]
  8. Wait about 5 seconds
  9. Monitor [OUT 1] and adjust P205 for 5.0VDC
  10. Monitor [OUT 2] and adjust P206 for 5.0VDC
  11. Monitor [OUT 3] and adjust P207 for 5.0VDC.
 
Email:  elby-designs@bigpond.com
© Copyright 2000. All rights reserved.     Revised: February 10, 2026