Let's Go Shopping
CGS309
Voltage Controlled Divider
Let's Go Shopping

3D Model

This was originally developed as a timing accessory for a sequencer Ken was working on, though when fed from a VCO, interesting frequency trills like those of the old 8-bit computer games can be produced. Feeding the control voltage from a Psycho LFO produces some interesting effects.

There are two outputs, one [PULSE] is a narrow "trigger" pulse, the other [PWM] follows the pulse width of the incoming signal. This means that any mark/space ratio sweep being applied to a VCO connected to this module, will also be on the output signal of this module.

The division can be varied from 'divide by 1' to approximately 'divide by 60'

 

PCB Dimensions: 2" x 6" with 3.2mm fixing points 0.15" from the edges
Power Consumption: +12V @ -12V @

Article, art & design copyright 2003 by Ken Stone

Email:  elby-designs@bigpond.com
© Copyright 2000. All rights reserved.     Revised: December 14, 2020