Made from a high-quality aluminium they are irridium plated for improved electrical conductivity and anodised for a tougher surface finish and form the basis of any sub-rack. Each Rail has 1 x M5 tapped hole at each end. The addition of a Side Plate at each end allows the assembly to be secured from inside your enclosure. Rails have a slot towards the front to accept our Tapped Strips or Rack Nuts which must be purchased separately.
2 pieces required per 3U section.
These Rails are physically 1HP longer than the quoted module spacing e.g. 84HP Rails are 85HP (431.8mm) long
Rail lengths up to 397HP (2m) are available on special request (MOQ may apply)