Studio 300 System


60mm deep Skiffs based on the Studio 500 build concept

42HP, 84HP, 104HP, 126HP and 168HP wide, 6U x 60mm deep skiffs

Studio 300 Skiffs can also be reconfigured as lids for all of the Studio 700 series, the Studio 500 single Desktop members and, of course, the Studio 300


Studio Kits

Kits contain Desktop End Plates (x2) , Desktop Skins(as required by selected width), Rails (x4), Tapped Strips (x4) and hardware.


Made from a high-quality aluminium they are irridium plated for improved electrical conductivity and anodised for a tougher surface finish and form the basis of any sub-rack. Each Rail has 1 x M5 tapped hole at each end. The addition of a Side Plate at each end allows the assembly to be secured from inside your enclosure. Rails have a slot towards the front to accept our Tapped Strips or Rack Nuts which must be purchased separately.
4 required for each 6U unit

Tapped Strips

Tapped Strips slide in to a dedicated slot near the front of the Rail and are used to accomodate module fixing screws and are tapped to take M3 module fixing screws. The design of the Tapped Strip allows them to be end-stackable to make longer lengths than the standard 84HP length.
We can also supply M3 Square Rail Nuts and Tapped Strips with M2.5mm tappings.

Busboard Mounting Kit

A Carrier Plate and mounting hardware to install one of our ED704/ED705 busboards in to your system. One kit is required for each busboard and one busboard can be mounted in to each 42HP section of the system